In that case we EDM'd .005" out of the motor sprocket taper to overcome the problem rather than dissasembling the motor but we only had to move it
.020" or so. It's been a while so the distance is a little foggy.
mister_blank
In that case we EDM'd .005" out of the motor sprocket taper to overcome the problem rather than dissasembling the motor but we only had to move it
.020" or so. It's been a while so the distance is a little foggy.
Last edited by sswaney; 11-18-2019 at 07:14 AM.
senior member
I sent you a PM
Posting Permissions
Reply With Quote