Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: 1936 VLD Carb support bracket

  1. #11
    Join Date
    Jun 2001
    Location
    Central Illinois, USA
    Posts
    4,302

    Default

    Its a fat hex in your second pic, NCRiding!

    The bolt that the lowspeed pivots upon, when you work the choke.
    (It should be a 3/8" hex.)

    Your bowl didn't originally use a gasket, and repops are fat for later M53s and such.
    (I punch thin paper ones for modern hygiene, and a few thou in float height shouldn't be that critical, as long as it is reasonably "square" to the top.)

    Kits always have crap you don't need, or crappy in other ways.
    (Its where vendors hide their 'seconds'.)

    ....Cotten
    PS: I'd post a pic, but the vendor isn't here to defend himself.
    Last edited by T. Cotten; 11-09-2019 at 09:52 AM.
    AMCA #776
    Dumpster Diver's Motto: Seek,... and Ye Shall Find!

  2. #12

    Default

    NCriding

    PM sent

    Steve

  3. #13
    Join Date
    Sep 2001
    Location
    United States
    Posts
    466

    Default

    Quote Originally Posted by Steve Slocombe View Post
    To answer Jim's question, yes that's the way VL engine numbers run, with the different models interleaved in the Big Twin number series. The small twins would have a separate series, so 35VLD1234 and 35RLD1234 would still be OK. You can see this in the VL Register, which records the 1200 or so VL engine numbers collected over the last 20+ years, where occasionally two consecutive surviving serial numbers are from different models, eg VD and VLD.

    That is interesting! Thank You Steve!
    Jim

    AMCA #6520

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •