Page 2 of 2 FirstFirst 12
Results 11 to 15 of 15

Thread: L.A. Sleeve

  1. #11
    Join Date
    Jun 2018
    Location
    Chicago
    Posts
    57

    Default

    as to the separating of cylinders . . . one of the most common issues in the past is that sleeves were fit with too high an interference value on cylinders that were already thin and may/may not have had their bore centerline square with the base flange after several rebores. This is especially true on iron/iron motors which tend to behave a bit differently when bolted down and fully warm than alloy/iron or alloy/alloy combinations. Many "vintage" motors also do not have through studs and substantial force is present at the cylinder base/case/spigot interface. Failure to double check the spigot to case clearance can cause issues blamed on the sleeving process as can torque induced distortion of the entire barrel.

    When done with care and attention to detail, there is no reason a sleeve cannot outlive a non-sleeved cylinder.

  2. #12
    Join Date
    Jun 2001
    Location
    Central Illinois, USA
    Posts
    4,021

    Default

    Here's a gem, Folks...

    The boreman didn't even sharpen the tool for cutting the casting, leaving such chatter and toolmark that it insulated the Chief sleeve shown in the attachment.

    A thou and a half is all that's necessary to hold the sleeve, and transfer heat, but it sure helps to hone the casting to a fine finish.
    This one required an expensive over-size LA replacement.

    When the final bore was finished for the piston, it still distorted dramatically more than a stock cylinder when torque-plated.

    ....Cotten
    Attached Images Attached Images
    Last edited by T. Cotten; 06-20-2019 at 04:22 PM.
    AMCA #776
    Dumpster Diver's Motto: Seek,... and Ye Shall Find!

  3. #13

    Default

    I would describe that finish as "10% knurled"

  4. #14

    Default

    The only bad outcome in which I know a LASCO product was employed was several U/UL (11 fin, 120-38/381) cylinders, originally 3-5/16" bore, which had VL/UH/ULH sleeves (3-27/64" ID, 3-9/16" OD) installed. AFAIK not LASCO's fault, some shop didn't see a UL sleeve (their EL sleeve is the right OD but too short) and bought the wrong one.
    The cylinders cracked across at the guide ledge, being the large change in cross-section plus the valve spring levering upward from the pinion side.

  5. #15
    Join Date
    May 2005
    Location
    NH
    Posts
    446

    Default

    We did a piece on Millennium Technologies in the magazine a while back https://www.millennium-tech.net/

    They claimed to be able to put as much as .05" per wall, and then hone it with special diamond tools. In that process no additional cylinder material is lost. I have not used them myself, but they do hundreds of cylinders a month and seem to understand exactly what they are doing.
    Dan Margolien
    Yankee Chapter National Meet August 3/4 2018 NEW LOCATION at the TERRYVILLE FAIRGROUNDS, Terryville CT http://www.bing.com/local?lid=YN873x...ir&FORM=SNAPST
    Yankeechapter.org
    pocketvalve@gmail.com
    JD enthusiasts: http://autos.groups.yahoo.com/group/harleyjd/

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •