Chrome Stripping

[Rex]

I have a reproduction skull dash and square tool box that I'd like to have painted but are currently chromed. Is it better to have them stripped, or buy new raw ones?

I don't want to pay for shipping, stripping, etc. just to find they won't accept paint.

[KNUCK]

I twice have had to powder coat over chrome on some forks and also some paint on other items. I took it to a shop and had the parts blasted with a special media like walnut shells or something like that. The chrome needs to be good, not peeling. I used CAP'S here in Calif, 559-233-1461 ask for Ron.
Never a problem with peeling paint later!

[Erdos]

I would just have them stripped. A chromer will do it for you cheap since all their cost is in the labor of buffing.

[Kozy]

Can steel pieces be parkeized after the chrome is stripped? Does stripping remove the copper and nickle?

[Erdos]

My stripper removes the chrome and the nickle. As for the copper I just bead blast it off.

[Perry Ruiter]

I've parkerized lots of stuff that was chromed. I tell the plater I want it back bare metal and I get it that way ... Perry

[swall]

You can use battery acid diluted 50%, electrolytic. Hook your piece to the positive terminal, hook the negative terminal to a dummy piece of clean steel and immerse in the acid, keeping the positve and negative from touching. This will remove the nickel and chrome. To get the copper off, use houshold ammonia, no electrical current. The latter process is slow, however. I did my Indian speedo dash panel this way so I could weld up some holes prior to replating.

[rousseau]

Swall
I'm guessing DC current here . What do you use? Car battery? Battery charger? Rectifier? How many volts?
How about a little more detail Please.

[Paps]

I have that proceedure hidden around here somewhere. I will look for it over the weekend. As I recall you use a 12 volt car battery and you do the job outside up wind of the fumes created. Don't forget about acid disposable problems also. Paps

[swall]

Yes, 12volts,using a car or motorcycle battery. Process takes 5 to 10 minutes.Acid recipe from Caswell Plating is 3 parts acid to 1 part distilled water. I ran a little short of acid and used 2 parts acid to 1 part water. You need enough to completely cover the part.