Search:

Type: Posts; User: Rubone

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    12
    Views
    532

    You can replenish it with this.. ...

    You can replenish it with this..

    https://imagizer.imageshack.com/v2/1024x768q90/923/FHlXM7.jpg
  2. Steve, The -38 lights are the commonly referred...

    Steve,
    The -38 lights are the commonly referred to three rivet type. They are not sided, and when used as running lights one is upside down. The -49 type are sided. The early ones shown in those...
  3. Replies
    2
    Views
    214

    They were not part of the Deluxe group. They were...

    They were not part of the Deluxe group. They were available over the counter.
  4. Replies
    22
    Views
    1,034

    All brands of bikes like accessories.

    All brands of bikes like accessories.
  5. Replies
    3
    Views
    581

    Hi Cliff, I have a '71 and a '72 CT90s around...

    Hi Cliff,
    I have a '71 and a '72 CT90s around here. They are a bit rough though!!
  6. Replies
    25
    Views
    856

    Tim, 6 page PDF in your email. Robbie

    Tim, 6 page PDF in your email.
    Robbie
  7. Replies
    7
    Views
    388

    Make sure the transmission vent isn't plugged up....

    Make sure the transmission vent isn't plugged up. When running the pressure build-up in the case needs to go somewhere and if the breather is plugged the pressure will find the next weak spot to exit...
  8. Replies
    9
    Views
    652

    Change the plugs.

    Change the plugs.
  9. Replies
    8
    Views
    369

    No worries Llama, keep doing what you are doing....

    No worries Llama, keep doing what you are doing. Many of us here love it.
  10. Replies
    25
    Views
    856

    I can scan it and send it to you Tim. PM me your...

    I can scan it and send it to you Tim. PM me your email.
    Robbie
  11. Replies
    25
    Views
    856

    There were several variations of the pump for...

    There were several variations of the pump for '73. Any common replacement type would be fine, S&S etc. This is the factory info.
  12. Replies
    7
    Views
    595

    Linkert changed bodies often even with the same...

    Linkert changed bodies often even with the same designations. The 3 was a later version than the 2 as is obvious with the body changes. You can tell that the later body was already in use or near so...
  13. Replies
    4
    Views
    383

    Note that the "NEW" Indian Warrior was introduced...

    Note that the "NEW" Indian Warrior was introduced for 1950.. My scan is from a copy of American Motorcyclist of that era. Without digging through them I don't know what month, But I have all of them...
  14. Replies
    4
    Views
    383

    It is this one,

    It is this one,
  15. Thread: L.A. Sleeve

    by Rubone
    Replies
    14
    Views
    1,179

    Which is always a possibility no matter who...

    Which is always a possibility no matter who sleeved it.
  16. Replies
    4
    Views
    511

    It says you are a new member to the forum, and...

    It says you are a new member to the forum, and will do so until you exceed a certain number of posts.
  17. Early rods had a "window" in them. it worked just...

    Early rods had a "window" in them. it worked just fine with the baffled cases where crankcase pressure and oil mist was the source of cylinder lubricant. When the rods were reversed, the "window" was...
  18. It isn't a fitted item. The so called "dust ring"...

    It isn't a fitted item. The so called "dust ring" is merely a debris deflector, not a seal.
  19. Replies
    14
    Views
    1,023

    The dash/speedo mount has been replaced. Those...

    The dash/speedo mount has been replaced. Those are also non-standard welds by the rear stays to top tube.
  20. Replies
    2
    Views
    290

    Ollie and Shunk (not skunk) are aftermarket....

    Ollie and Shunk (not skunk) are aftermarket. Savannah refers to the race track in Georgia and was a performance race shop grind.
  21. I have used Boyer-Bransden in the past with good...

    I have used Boyer-Bransden in the past with good results. Use non resistor plug wires. No more fiddly auto advance. Be aware of polarity though, if hooked up wrong it can cook it quickly. And a solid...
  22. Replies
    42
    Views
    2,710

    This is fact. Nearly all heavy industry at that...

    This is fact. Nearly all heavy industry at that time was in the north, with Southern Wisconsin, Northern Illinois, South Michigan, Indiana, Ohio, PA, all in the middle of it. The Firearms industry...
  23. Replies
    9
    Views
    902

    I wouldn't sell any of it until you sort through...

    I wouldn't sell any of it until you sort through it all and determine if any of it originally went together.
  24. Replies
    1
    Views
    302

    In the same year range, nothing!

    In the same year range, nothing!
  25. Replies
    9
    Views
    972

    Wheel covers on a H-D.

    Wheel covers on a H-D.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4