Search:

Type: Posts; User: JURIS R.

Search: Search took 0.00 seconds.

  1. Replies
    11
    Views
    5,391

    Hi Tom and others, I had no luck with Starklite...

    Hi Tom and others,
    I had no luck with Starklite -- e-mailed, faxed and called them several times, then they were closed for a longer period and I left messages on the answering machine, etc. Then
    I...
  2. Replies
    11
    Views
    5,391

    Hello Tom, Thank you for your reply. I will do...

    Hello Tom,

    Thank you for your reply. I will do as you advise and will rebabbit with tin babbit -- I have a new rod boring bench -- a Zanrosso, so machining should not be a problem apart from...
  3. Replies
    11
    Views
    5,391

    402 rods puzzle

    Hello Red Fred,

    Thank you for your advice regarding who to call at Starklite. I did reach them once on the phone, but was not so lucky the second time as their answering machine said they are...
  4. Replies
    11
    Views
    5,391

    Hi Old Chief, I have e-mailed, faxed and poned...

    Hi Old Chief,

    I have e-mailed, faxed and poned Starklite Cycles, enquiring about Vertical Twin rods in December and then the beginning of last week. There was a promise to check availability and...
  5. Replies
    11
    Views
    5,391

    Hi, I am located in Latvia, that is a Baltic...

    Hi, I am located in Latvia, that is a Baltic state in Europe just across the Baltic sea from Sweden -- so basically somewhat on the other side of the Globe. I have e-mailed and faxed Bob (no reply...
  6. Replies
    11
    Views
    5,391

    402 rods puzzle

    Hello Old Chief,

    Thank you very much for your lead. I have googled Starklite Cycle, found their e-mail and sent off an enquiry, that is much easier for me than calling, besides they may be closed...
  7. Replies
    11
    Views
    5,391

    402 rods puzzle

    Hello All,

    As my 1929 402 5-bearing crank engine came with the wrong rods - the 1936-1937 type and they have too narrow between-the-studs distance for conversion to babbit-lined bronze or B-850...
  8. Replies
    0
    Views
    1,498

    1926 Prince comp. height

    Hello,

    Could anyone kindly advise the compression height of a 1926 SV Prince? Most of the people I have contacted so far do not have a Prince piston handy to measure as most of them (pistons) are...
  9. Replies
    17
    Views
    10,570

    Peter, I have been reading your posts very...

    Peter,

    I have been reading your posts very carefully as I am based in Latvia, a Baltic state in Europe and with regard to restoration of my 1929 Indian 402 I am in complete isolation, like living...
Results 1 to 9 of 9