Search:

Type: Posts; User: dustydog

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    235

    The one black wire from the distributor to the...

    The one black wire from the distributor to the neg. post on the coil is all you need. I don’t know why you have another wire there. Another wire runs from the coil pos. Post to the ignition switch....
  2. I sent you a PM

    I sent you a PM
  3. The spacer and large bearing go into the case....

    The spacer and large bearing go into the case. The main drive gear goes into the bearing up to it’s shoulder and stops. The main shaft goes into the main drive gear up to it’s shoulder and stops. No...
  4. Replies
    10
    Views
    657

    Try Bill’s custom cycles in Bloomsburg, Pa

    Try Bill’s custom cycles in Bloomsburg, Pa
  5. Replies
    5
    Views
    306

    It might take more than 2 beers.

    It might take more than 2 beers.
  6. Replies
    5
    Views
    306

    Steve you have two different spirals right now....

    Steve you have two different spirals right now. You need to get another one like your throttle. It is hard to picture in your head but remember, the same spiral that pushes when used on one side will...
  7. Replies
    15
    Views
    1,105

    And don’t look down the bore of the tube

    And don’t look down the bore of the tube
  8. Replies
    15
    Views
    1,105

    Thank you everyone for all the replies

    Thank you everyone for all the replies
  9. Replies
    6
    Views
    571

    It was a beautiful day today. Will be nice again...

    It was a beautiful day today. Will be nice again tomorrow
  10. Replies
    15
    Views
    1,105

    Yeah that’s the problem. The plug hole is not...

    Yeah that’s the problem. The plug hole is not directly over the top of the piston.
  11. Replies
    15
    Views
    1,105

    Cotton does the air pressure in the cylinder move...

    Cotton does the air pressure in the cylinder move the drop of oil up and down in the tube?
  12. Replies
    15
    Views
    1,105

    Wow! Those were fast replies. I was thinking...

    Wow! Those were fast replies. I was thinking about the camera method. I think I already have some questionable spark plug type tool. But I think Cotton is right. It’s a low tech job. Thanks you guys.
  13. Replies
    15
    Views
    1,105

    Finding top dead center

    What is the best way to find TDC on an Indian 4? I’m
    trying to check the timing and the manual says to stick a piece of wire in the spark plug hole. That doesn’t seem to be very accurate but what...
  14. Thread: Bendix Carb

    by dustydog
    Replies
    5
    Views
    628

    Get the 38 mm kit. There is only one jet and it...

    Get the 38 mm kit. There is only one jet and it should be the .115. The original .115 jets are marked c66-143. Set the float at 3/16 with the gasket in place. Mixture screw should be set at 1 1/2...
  15. I get .120 on mine. It looks just like yours.

    I get .120 on mine. It looks just like yours.
  16. Thread: 1952 Chief

    by dustydog
    Replies
    13
    Views
    7,844

    Great job on a beautiful Chief

    Great job on a beautiful Chief
  17. Replies
    5
    Views
    814

    Thanks Chris and Steve. A picture is worth a...

    Thanks Chris and Steve. A picture is worth a thousand words.
  18. Replies
    5
    Views
    814

    That bar and shield decal must be the patent...

    That bar and shield decal must be the patent decals I’ve seen. Thanks Chris
  19. Replies
    5
    Views
    814

    1934 Vl decals

    Can someone tell me what the correct decals are for a ‘34 VL and where they go? I’m taking about the patent and trademark type decals not the big tank decals. Thanks
  20. Replies
    9
    Views
    1,793

    I see the outboard half of the caliper has a boss...

    I see the outboard half of the caliper has a boss at the left side. Sometimes the boss has a hole drilled through it and sometimes not. What’s up with that?
  21. Replies
    9
    Views
    1,793

    Thanks Rubone. Do you know why.

    Thanks Rubone. Do you know why.
  22. Replies
    9
    Views
    1,793

    Banana calipers

    What is the difference between front and rear calipers on the early banana style. I don’t see any difference.
  23. Replies
    18
    Views
    2,900

    Here’s some more

    Here’s some more
  24. Replies
    18
    Views
    2,900

    Here are some pictures of Bubbalowe’s TLEU...

    Here are some pictures of Bubbalowe’s TLEU sidecar on a round swing arm shovel. He made all of the mounts himself. Nice job.
  25. Replies
    18
    Views
    2,900

    Ah this is bad news. You are just in time I think...

    Ah this is bad news. You are just in time I think I can stop the machinist in the morning. We’ll I’ll have to rethink this. It may be easier to find the correct sidecar. I’ll have to talk to the...
Results 1 to 25 of 98
Page 1 of 4 1 2 3 4