Search:

Well I'm later than you responding, but thanks for the response, did get the decals. Very nice bike Zommin; I've saved the photo. When done I'll have roughly the same look. Thanks again.

Thanks for the replies

At the point of a restoration where I'm ready for paint. The saddlebag tops have some chipping on the edges just under the lip. I was wondering if anybody has a good recommendation for treating...

Thanks again Lonnie!
Tim

Thanks for the info Lonnie and the link; the black looks good! Do you know where I can get any of the decals?

Anyone have a vendor that could provide the right tank decal for a black 1972 FLH; I beleive it's part #61146-72. The reason I mention the color of the bike is because the black bike tank decals are...

Anyone have a vendor that could provide the right tank decal for a black 1972 FLH; I beleive it's part #61146-72. The reason I mention the color of the bike is because the black bike tank decals are...

Thanks for the info Steve.

Had some parts in a box for years, was wondering if the old tags on them were accurate. They read, see picture:
Left (vlh crankcase stud #6, right end of stud)
middle (#7 front thread fit vlh)...

Thanks Scott, left message.
Tim

Looking for the forward terminal board for my 1972 FLH. The part is under the nacelle and is HD part# 72311-70. These seem to be tough to find; any recommendations or suggestions? I put this in...

Thanks, I'll try Bill's

Looking for a terminal board for a 1972 FLH (under the nacelle) Harley Part#72311-70. I think they were only used from 70 to 72 and they seem to be hard to find. Any suggestions?

Thanks
Tim

Thanks for your help Chris.

Tim

Restoring a 1972 FLH, that I let go in the 70s and re-bought in 2010. Wondering if there is some written guide (electronic or paper) that guides one through the process of rebuilding, checking out,...

Mike and Kyle, thanks for the info..very helpful
Tim

5989Hopefully this picture comes through. Just behind front engine bracket on lower left.

Your right the tab is on the lower left bottom tube just rear of the front engine mount bracket, behind the shifter cover. Small hard to see and get to on a complete bike. I have a great picture of...

Jerry, thanks. Photo would be great. Does anyone have the dimmensions of the tab; height from frame tube to top, width, thickness; size of hole that's in it, or a site that I can look up frame...

Cory, thanks so much for the effort and the info.

I have a 1972 FLH I'm restoring. Seems to be a tab missing (just a stub there) on the lower left frame tube bottom, just rear of the motor mount cross bracket. On other frame diagrams I can see the...

Greetings! Was a member a few years ago while rebuilding a 1942 WLA. I'm back, because I just re-bought a 1972 FLH (that I owned previously in the 70s.) I need to start looking for parts and I'm...