Only registered users may post on this forum. You must be an AMCA member to register. Click the register link on the top right to proceed.
I got this with some other parts. I am more familiar with the later pans, so I don't know what this is. Looks like leather. There is an "august"...
Every day I learn how little I know. Although I have only had a handfull of M74 (no B) models cross my benches, none had an unusual highspeed...
I have about 5000 miles on my 64FLH and its been running great. Accurate Engineering completely rebuilt the engine and Im running the original oil...
Hi, does anybody know where I can find an original Wagner-Lockheed rear master cylinder for my '63 FLH? I had my dealer run a dealer link and could...
Hi everyone. Just wanted to introduce myself to the panhead crowd. I just picked up a '48 EL a few weeks ago and thought it would be good to join...
Hello all, for the life of me I can't seem to find a correct rear fender for my 58 FLH. I do have a reproduction one, but a bit reluctant to put it...
I have two styles of lower legs . one has the boss for the drain plug at the bottom on both sides .The boss on the front side is not drilled. The...
I have a couple of early triple trees . Some have a 3/8 coarse thread pinch bolt for the tubes and some are 7/16 fine thread . Any body run into this...
Hi folks does anybody know of a shop that can restore my pan lower legs (fill in a couple deep scrapes and polish,repair stripped fender bolt holes...
Hi there. i have a discussion with a friend here about the 49 only black painted lower legs. i'm pretty sure they are sand cast aluminum but he...
I bought a chopped and bobbed 50 pan. After reading the Palmer restoration book, I am not so sure that it has an original 50 wishbone frame. The...
I am trying to determine if the handlebar clamp cover on my 65FL is correct or not. I have been told the one on my bike is incorrect. I looked in my...
Good afternoon lads, Trying to figure out a wire routing problem on my 48FL. The bike in the picture below was and original paint at Oley 09. It is...
I have a 1948 Front head off a panhead with a date code A-8. would that break down to indicate Jan 1948? If not, otherwise, how does one decifer the...
Hi everyone, I'm a new member and of course need help. I purchased a couple basket cases over 25 years ago, a 52 PAN and 47 INDIAN. The PAN actually...
Hi, I'm looking for a set of nice original fork caps for my '58 FLH. Any help would be greatly appreciated.
Who has correct exhaust tubes? (rivet flags and saddled y-pipe) For DuoGlide Thank you!
I have one for sale Dan 913 268 5314
what is the difference between a buddy seat t mount and a solo mount t mount. my 50 had a buddy seat but I want to run a solo seat now do I need a...
I am rebuilding my 52e 3 brusk generator. One of the field coils is bad and needs replacing. I have discovered that the generator has 32e field coils...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
