View Full Version : Rear passenger pegs.
01-13-2012, 08:11 AM
I am trying to figure out how the spring loaded right rear passenger foot rest works? I have the NOS stud and spring but have never actually seen one in person. If some one could provide a close up picture of this set up that would help a lot. I am putting together a 1961 XLH. Thanks
01-17-2012, 08:20 PM
Hope this picture will open large enough so you can see details of spring. http://s681.photobucket.com/albums/vv1781blupacer.
01-19-2012, 01:27 PM
sorry, do not know to post picture, will try again
right side stud #52680-52 points to rear of bike ,through spring into footrest bracket, large loop on spring goes on under side of peg
01-21-2012, 09:16 AM
Can you email picture? firstname.lastname@example.org
07-15-2012, 11:10 PM
I finally installed rear pegs on my '56 KHK. I gave up trying to find the correct set up and settled on modifying a set from an early Sportster. This meant quite a bit of bending and use of 1/4" spacer plate; however, the finished result should work fine.
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.