PDA

View Full Version : Custom Reamer



Bill Pedalino
05-09-2005, 08:01 PM
Does anybody know of a concern that will make custom-sized reamers or cut down a standard reamer to an offsize? I need to replace a Harley Overhead oil pump shaft bushing and will neet to ream it after pressing it in.

Thanks....

T. Cotten
05-09-2005, 10:49 PM
Bill!
You might try http://www.aerosharp.com/aerosharp_home.htm

But most of us would just hone it.

(I must drive at least a dozen miles to the nearest machineshop that can grind a reamer. Are they getting rare?)

Paps
05-10-2005, 09:24 AM
MSC Industrial Supply has made reamers and milling cutters to my specifications in the past. Pretty reasonable folks too. Paps

http://www1.mscdirect.com/cgi/nnsrhm

Bill Pedalino
05-10-2005, 09:26 AM
Thanks for the reply. I will most likely have it honed, as I no longer have access to a sunnen hone.

I was looking through my data and can't find the running clearance for the Harley FL oil pump drive shaft-to-bushing. Does anyone have that info.???