- What do I have?
- Beehive tail light
- Spotlights for a 37E Knuckle
- 39 - 46 Speedometer Dash Base lamp contact
- Tool Box Identification and mounting help please - Thumb Screw Style
- Jim Ramsey
- M-25 carb.
- New Knucklehead Cases
- Finally got the Knuck on the road today!
- Front Fork Springs (Where to obtain) 42 EL
- Torque Values - Head and Cylinder 42 Knuckle
- 42 EL sputtering when cold
- V-Twin Coil
- Two questions: 1) Tank decals 2) Head repair
- early notched cam cover & EX1337 tranny top
- Ebay Knuckle
- Buddy Seat Alternative 42 EL with Solo
- For the Knuckle Junkies.....
- Wiring Diagram for 37EL
- What happened to the '36EL that was in the garage in Oildale, CA?
- Correct Seat T for 1939 EL
- Kicker Petal won't stay put
- Pre war copper fuel and oil lines
- Vard swap
- HELP PLEASE '47 Wiring HELP PLEASE
- Production Numbers, how many did they make of a certain model?
- 1947 Dash
- Knucklehead plug issues
- Brake shaft lever
- Spirals and Controls Question
- Frame Restoration
- M 5 Nozzle?
- Welding/reparing Engine cases
- '47 Front Fender Light Help Please
- copaltite sealing compound
- Knucklehead compression
- 1940-1946 tank badge question
- Leaking tins
- 1947 Bull neck frame
- linkert choke lever
- 1936-1940 Foreward sweep springer
- 47EL tranny gears recommendation
- 1938 61" Knucklehead Bonneville bike on the dyno
- Crippled
- Fender light wiring route
- knuckle primary leak
- Luggage racks
- Looking for Original Paint 1936 Knucklehead to answer a question
- 1947 FL Question
- Dash-Mounted Linkert Choke Control
- Spirals--long & short
- Casting codes
- 1936 OHV brake pedal
- J. Ramsey
- 46FL steering damper assembly
- 46fl Steering damper rod
- Vintage Harley parts
- Rear Stand Lift Technique
- Skip Pieper
- 47 knuck tanks needed!!
- 1946 Dash Base
- mystery oil tank
- another oil tank picture
- oil tank picture
- 47 Rear fender
- Correct Cycleray headlamp lens for 1937 and 1939 models
- Right hand shifts
- front drum
- Springer front wheel bouncing up & down
- frame measurement question
- Tire pressure on springers